Dolby Laboratories DP524 Manual de usuario descargar pdf (Pagina 15)

DP571 Dolby

E Encoder User’s Manual

Chapter 2

Hardware Installation

This chapter explains how to put the unit into service.

2.1 Unpacking

Before unpacking the unit, inspect the outer carton for shipping damage. If the carton

shows damage, inspect the unit in those areas.

The following accessories are provided with the unit:

• Rack screws and washers

• Power cord

• BNC 75Ω terminators for use on Digital Audio and Video Ref inputs

(Part No. 79114)

• Spare fuse 1A (Part No. 56016)

• Hex wrench (to access inside of unit)

• Quick start guide

• Registration card

Carefully remove the unit from its carton, remove the plastic wrapping, and place on

a flat surface. If there are no signs of damage, proceed to check the fuse as shown on

page ix.

2.2 Placement Considerations

Dolby professional audio products are designed to operate within a temperature range

of 5° to 45° C. They use natural convection cooling and therefore should not be

mounted directly above any heat-generating equipment. The DP571 and DP572 units

are vented on the left side of the top and bottom covers. The vent holes should not be

blocked, although units can vent through one another if necessary. The number of

units that can be vented in this way will depend on the conditions of the rack in which

they will be installed.

2.3 Connecting Inputs and Outputs

After the unit is installed in its permanent location, connect its inputs and outputs.

The DP571 accepts a variety of connections. See Section 6.2 for details.

2-1

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 44 45

Sin comentarios

Dolby Laboratories DP524 Manual de usuario Pagina 15