Dolby Laboratories DM100 Manual de usuario descargar pdf (Pagina 15)

Dolby

DM100 User’s Manual Getting Started

2-7

2.6 Quick Start

The DM100 is designed to be easy and intuitive to use. Follow

these simple procedures to begin taking your first readings and

generating your first test streams.

Making Your First Reading

1. Turn on the unit by pressing [Power].

2. Connect the input signal to the appropriate connector.

3. Press [Mon]. This resets all the internal monitoring setup

functions to the defaults.

The LEDs should display the signal type received, and the

display shows information about the incoming signal. If you

cannot see this information, press [Status], then use [Enter],

[Esc], and the [Up/Down] buttons to navigate through the status

menus to view information about the incoming signal. See

Section 3.2 for additional information.

Adjust the audio level with the dedicated [Volume] buttons.

Generating a Bitstream

1. Press [Gen] once. This turns the generator on and outputs a

PCM test signal.

2. To select other test streams, continue to press [Gen].

Different clock sources can be used for the generator; these can

be selected in the Gen Clock Source menu:

Setup / I/O Control / Gen Clock Source

See Section 4.5 for more information.

To read the current status of the generator, press [Status] and

navigate using the [Down] button until Generator Enter to

View is displayed. Press [Enter] to see the current settings. See

Section 3.2.5 for more information.

You can even connect the output of the DM100 to the input.

Doing this allows you to listen to the test stream and view all of

the streams’ settings.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 64 65

Sin comentarios

Dolby Laboratories DM100 Manual de usuario Pagina 15